2. Non-toxic, tough, hard, hard to break, good temperature resistance and creep resistance.
3. Good print precision, no warping, stripping or stringing.
4. eSmooth is easy to absorb water, so better drying before print. Remember to choose an ethanol solution over 99.7% purity and work with a spray type polisher for polishing.
5. Environmentally friendly, stable performance, more refined and brighter after polishing, complete decomposition, no carbonation and no residue in 600 ℃, can be used for metal casting
Elongation at break
Notch impact strength
eSmooth printing parameters
1,Best print temperature: 190-210℃
2,Bed temperature: 45-55℃
3,Feed rate: 30-90mm/s
4,Idling speed: 90-150mm/s
1,Leveling printing plate before starting;
2,Heat the hot bed to 45~55℃ before printing, paste transparent golden polyimide high temperature resistance tape to the surface and keep it clean;
3,Keep a optimumdistance between nozzle and plate (which allows you to paint out a flat line while moving your nozzles; if too far the line will be much mellow and too close will be hard to let filament out);
4. A lower filling rate can print finer articles (about 20%~ 30% degrees);
5,Nozzlediameter should be bigger than layer thickness. Try parameter like 0.2, 0.25, and 0.3;
6,No need to print in a closed area.
1,Hang the prints in the air to make a full contact with ethanol vapor. The whole process takes 20-30 minutes.
1, The prints normally turn white and soft. Just use tweezers or other tools for air drying. Do not touch bare hands.
3,To achieve best polishing effect, 3-5 days air drying will volatilize solvent on surface and form a hardened layer. Do not dry with oven, or the solvent will volatilize and destroy polishing effect.